JMICRON JMB363 ESATA DRIVER DOWNLOAD

Trying to do that in the option ROM causes a several-minute hang during boot when loading the option ROM again, seemingly waiting for a disk and giving up , even when a PATA disk is present. I have not used this tool before; investigate it for yourself before installing unknown software. Post Your Answer Discard By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of service , privacy policy and cookie policy , and that your continued use of the website is subject to these policies. Given my limited abilities to understand hex, I cannot locate where to apply the changes to. Sign up using Email and Password. Also tried many different driver revisions.

Uploader: Tozahn
Date Added: 1 April 2018
File Size: 17.43 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 72183
Price: Free* [*Free Regsitration Required]

Why do you want to avoid the on-board SATA controller?

Also tried many different driver revisions. You might try looking through the Linux kernel sources to see if the driver for the 88SE gives any clues as to how the chip works…. What am I missing?

It seems like bits [1: I did not experiment with the values of these bits except for toggling bit 6. Post Your Answer Discard By clicking “Post Your Answer”, you acknowledge that you have read our jm3b63 terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies.

  102WC WEBCAM DRIVER DOWNLOAD

By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies. Option ROM sets this to either 0xf1 or 0x I speculate its purpose is to disable jmicfon option ROM, allowing the main BIOS to set up the rest of the device configuration without interference.

Jkb363 made changes at three locations: Forums Search Forums Recent Posts.

JMicron JMB Add-on Card AHCI mode « Blog

If so, I would start with the first patched ROM the one that sets df[1: I want to create an AHCI patched verson of 1. Sorry, forgot to update CRC. Nov 7, 3. Option ROM not enabled by setting df[6], so the disks are not bootable. According to a SiliconImage knowledgebase article linked from HotSwap’s homepage, you may need to make sure the drive is powercycled unplug the power cable before reattaching the eSATA data cable.

Duufus, I had in the past this card: Linux sets register 0x41 to 0xa1, while the option ROM will set it to 0xf1 or 0x Do you already have an account? Actually, there is only one sata connexion, not two. The option ROM loads, correctly reports connected drives, and allows booting from them.

  3COM 2000T DRIVER

At this point in the code, register eata should contain the byte read from PCI configuration register 0xdf. Jmicrin sets register 40 bit 2 to enable the IDE port?

Stephen 1 3 9. Register Function 43 Defaults to 0x I’m using the latest BIOS on my jmiicron, as well. There is indeed a checksum byte. Do i need to fix a checksum value as well? I can’t seem to hot swap an external SATA drive. Nov 7, 2. Unfortunately, the file is quite different.

e-SATA terribly slow with JMicron JMB363

The settings were already as shown above. There were problems with OSX with the first patch which is why the second one exists. They might be similar enough you could replace one with the other, but they also might not be.